8061201 Festo Pneumatic Components

Product Details

• KC characters
  KC EMC
• Rotor position sensor measuring principle
  Magnetic
• Performance Level (PL)
  Safe torque off (STO)/category 3, performance level d
• Hardware fault tolerance
  1
• Rotor position sensor
  Absolute encoder, single-turn
• Safety integrity level (SIL)
  Safe torque off (STO)/SIL 2
• Diagnostic coverage
  90 %
• Max. negative test pulse on 1 signal
  600 µs
• Nominal current
  6.9 A
• Certificate issuing authority
  German Technical Control Board (TÜV) 01/205/5514.00/16 UL E331130
• Storage temperature
  -25 °C ... 70 °C
• Nominal torque
  0.37 Nm
• Permissible radial shaft load
  100 N
• Product weight
  1900 g
• Number of digital logic inputs
  2
• Characteristics of logic input
  Galvanically connected to logic potential
• Switching logic at outputs
  PNP (positive switching)
• Display
  LED
• Braking resistor, external
  6 Ohm
• Parameterization interface
  Ethernet
SFF safe failure fraction
> 90 %
Rotor position sensor resolution
12 bit
Shock resistance
Shock test with severity level 2 as per FN 942017-5 and EN 60068-2-27
Degree of protection
IP54
Controller operating mode
PWM MOSFET power output stage PI current regulator
Safety function
Safe torque off (STO)
Max. rotational speed
3500 1/min
Max. current of digital logic outputs
100 mA
Max. positive test pulse with 0 signal
10000 µs
Protocol
EtherNet/IP
Motor peak power
158 W
CE marking (see declaration of conformity)
As per EU EMC directive as per EU machinery directive
Ambient temperature
0 °C ... 50 °C
Rotor mass moment of inertia
0.175 kgcm²
Type code
EMCA
Protective function
I²t monitoring Software end position detection
Nominal rotary speed
3100 1/min
Characteristics of digital logic outputs
Freely configurable in some cases Not galvanically isolated
Motor nominal power
120 W
Peak current
10.2 A
Relative air humidity
0 - 95 % Non-condensing
Note on ambient temperature
Above an ambient temperature of 20 °C, the power must be reduced by 1.75% per °C.
Permissible axial shaft load
60 N
Ethernet, supported protocols
TCP/IP
DC nominal voltage
24 V
Max. number of positioning sets
64
Permissible voltage fluctuations
+/- 20 %
Vibration resistance
Transport application test with severity level 2 as per FN 942017-4 and EN 60068-2-6
Certification
RCM compliance mark c UL us - Recognized (OL)
PFD
1.86E-5
Logic input specification
Based on IEC 61131-2
Type of mounting
Screwed tightly With through-hole
Peak torque
0.85 Nm
PFH
1.0E-9
Proof test interval
20 y
Communication profile
FHPP
Number of digital logic outputs 24 V DC
2
Work range of logic input
24 V
Input switching logic
PNP (positive switching)
Note on materials
Contains paint-wetting impairment substances RoHS-compliant

8061201 Related Documents