8061199 Festo Pneumatic Components

Product Details

• Rotor position sensor
  Absolute encoder, multi-turn
• Performance Level (PL)
  Safe torque off (STO)/category 3, performance level d
• KC characters
  KC EMC
• Rotor position sensor measuring principle
  Magnetic
• Nominal rotary speed
  3100 1/min
• Max. positive test pulse with 0 signal
  10000 µs
• Safety function
  Safe torque off (STO)
• Display
  LED
• Hardware fault tolerance
  1
• Motor nominal power
  120 W
• Absolute encoder operating time
  With external battery: max. 6 months Note: the maximum service life of the battery depends its state of charge, the ambient temperature and ageing effects. Without external battery: 3 days (worst case) up to a maximum of 7 days (best case) Note: Maximum s
• Rotor position sensor resolution
  12 bit
• Storage temperature
  -25 °C ... 70 °C
• Permissible axial shaft load
  60 N
• Proof test interval
  20 y
• Characteristics of logic input
  Galvanically connected to logic potential
• Controller operating mode
  PWM MOSFET power output stage PI current regulator
• Safety integrity level (SIL)
  Safe torque off (STO)/SIL 2
• Max. rotational speed
  3500 1/min
• Max. current of digital logic outputs
  100 mA
DC nominal voltage
24 V
Max. number of positioning sets
64
CE marking (see declaration of conformity)
As per EU EMC directive as per EU machinery directive
Relative air humidity
0 - 95 % Non-condensing
Rotor mass moment of inertia
0.175 kgcm²
Product weight
1925 g
Logic input specification
Based on IEC 61131-2
Work range of logic input
24 V
Note on materials
Contains paint-wetting impairment substances RoHS-compliant
Type code
EMCA
Protective function
I²t monitoring Software end position detection
Diagnostic coverage
90 %
Max. negative test pulse on 1 signal
600 µs
Protocol
Modbus® TCP
Peak current
10.2 A
Shock resistance
Shock test with severity level 2 as per FN 942017-5 and EN 60068-2-27
Ambient temperature
0 °C ... 50 °C
Certification
RCM compliance mark c UL us - Recognized (OL)
PFH
1.0E-9
Number of digital logic inputs
11
Input switching logic
PNP (positive switching)
Braking resistor, external
6 Ohm
Characteristics of digital logic outputs
Freely configurable in some cases Not galvanically isolated
SFF safe failure fraction
> 90 %
Permissible voltage fluctuations
+/- 20 %
Certificate issuing authority
German Technical Control Board (TÜV) 01/205/5514.00/16 UL E331130
Note on ambient temperature
Above an ambient temperature of 20 °C, the power must be reduced by 1.75% per °C.
Nominal torque
0.37 Nm
PFD
1.86E-5
Communication profile
FHPP
Type of mounting
Screwed tightly With through-hole
Nominal current
6.9 A
Parameterization interface
Ethernet
Motor peak power
158 W
Vibration resistance
Transport application test with severity level 2 as per FN 942017-4 and EN 60068-2-6
Degree of protection
IP54
Peak torque
0.85 Nm
Permissible radial shaft load
100 N
Number of digital logic outputs 24 V DC
4
Ethernet, supported protocols
TCP/IP, Modbus® TCP
Switching logic at outputs
PNP (positive switching)

8061199 Related Documents