8063374 Festo Manifold Dispensers

Product Details

• Medium
  Liquid media
• Material number for dosing needle
  1.4301
• Width dimension
  9 mm
• Internal volume
  113 µl valve with fluid connections
• Nominal altitude of use above sea level
  <= 2000 m NHN
• Note on switching time on
  Depending on the configuration, environment and application
• Reset method
  Mechanical spring
• Vibration resistance
  Transport application test with severity level 2 as per FN 942017-4 and EN 60068-2-6
• Fluid connector
  UNF1/4-28
• Note on fluid connector
  Fitting enclosed for pneumatic tubing with 3 mm outside diameter
• Material of dosing needle
  High-alloy stainless steel
• Storage temperature
  -20 °C ... 70 °C
• Water flow rate at max. operating pressure
  2000 µl/s
• Note on switching frequency
  Dependent on the ambient temperature and installation state
• Typical dosing precision
  <1% CV for volumes >5 µl <2.5% CV for volumes between 1-5 µl
• Note on switching time off
  Depending on the configuration, environment and application
• Min. dosing volume
  5 µl
• Sealing principle
  Soft
• Nominal operating voltage DC
  24 V
• Degree of protection
  IP30
Note on materials
Contains paint-wetting impairment substances RoHS-compliant
Materials in contact with the media
ETFE High-alloy stainless steel
Electrical connection
2-wire Open end
Nominal width of dosing needle
1 mm
Relative air humidity
0 - 95 % Non-condensing
Application note
See application note (available on the support portal at festo.com)
Note on degree of protection
In mounted state
Switching time off
2 ms
Nominal width
0.8 mm
Type of control
Direct
Temperature of medium
5 °C ... 50 °C
Actuation type
Electrical
Type of mounting
With internal thread and centering sleeve
Duty cycle
100 % with individual mounting 50 % in case of block mounting (max. switch-on time 1 s)
Wire ends
Stripped
Product weight
18 g
Operating pressure
0 bar ... 0.5 bar
Note on dosing precision
Depending on the configuration, environment and application
Information on medium
Observe resistance of materials that come into contact with media
Contamination level
2
On switching time
7 ms
Type code
VTOE
Max. switching frequency
4 Hz
Shock resistance
Shock test with severity level 2 as per FN 942017-5 and EN 60068-2-27
Ambient temperature
5 °C ... 40 °C
Valve function
2/2, closed, monostable
Mounting position
Any
Nominal conductor cross section
AWG28
Cable length
0.15 m
Note on dosing volume
Depending on the configuration, environment and application
Length of dosing needle
30 mm
Electrical power consumption
1.8 W
Permissible voltage fluctuations
+/- 10 %
Corrosion resistance class (CRC)
0 - No corrosion stress

8063374 Related Documents