8063373 Festo Manifold Dispensers

Product Details

• Type of mounting
  With internal thread and centering sleeve
• Degree of protection
  IP30
• Note on switching frequency
  Dependent on the ambient temperature and installation state
• Information on medium
  Observe resistance of materials that come into contact with media
• On switching time
  7 ms
• Nominal width
  0.8 mm
• Nominal operating voltage DC
  24 V
• Fluid connector
  UNF1/4-28
• Duty cycle
  100 % with individual mounting 50 % in case of block mounting (max. switch-on time 1 s)
• Wire ends
  Stripped
• Cable length
  0.15 m
• Product weight
  18 g
• Typical dosing precision
  <1% CV for volumes >5 µl <2.5% CV for volumes between 1-5 µl
• Note on switching time on
  Depending on the configuration, environment and application
• Length of dosing needle
  30 mm
• Max. switching frequency
  4 Hz
• Valve function
  2/2, closed, monostable
• Materials in contact with the media
  ETFE High-alloy stainless steel
• Material number for dosing needle
  1.4301
• Width dimension
  9 mm
Storage temperature
-20 °C ... 70 °C
Water flow rate at max. operating pressure
1300 µl/s
Relative air humidity
0 - 95 % Non-condensing
Application note
See application note (available on the support portal at festo.com)
Medium
Liquid media
Electrical power consumption
1.8 W
Reset method
Mechanical spring
Permissible voltage fluctuations
+/- 10 %
Temperature of medium
5 °C ... 50 °C
Note on materials
Contains paint-wetting impairment substances RoHS-compliant
Mounting position
Any
Nominal conductor cross section
AWG28
Operating pressure
0 bar ... 0.5 bar
Note on dosing precision
Depending on the configuration, environment and application
Nominal altitude of use above sea level
<= 2000 m NHN
Note on degree of protection
In mounted state
Switching time off
2 ms
Type of control
Direct
Vibration resistance
Transport application test with severity level 2 as per FN 942017-4 and EN 60068-2-6
Corrosion resistance class (CRC)
0 - No corrosion stress
Actuation type
Electrical
Note on fluid connector
Fitting enclosed for pneumatic tubing with 3 mm outside diameter
Material of dosing needle
High-alloy stainless steel
Electrical connection
2-wire Open end
Nominal width of dosing needle
0.6 mm
Internal volume
113 µl valve with fluid connections
Note on dosing volume
Depending on the configuration, environment and application
Contamination level
2
Note on switching time off
Depending on the configuration, environment and application
Min. dosing volume
3 µl
Type code
VTOE
Sealing principle
Soft
Shock resistance
Shock test with severity level 2 as per FN 942017-5 and EN 60068-2-27
Ambient temperature
5 °C ... 40 °C

8063373 Related Documents