8063372 Festo Manifold Dispensers

Product Details

• Note on fluid connector
  Fitting enclosed for pneumatic tubing with 3 mm outside diameter
• Nominal conductor cross section
  AWG28
• Cable length
  0.15 m
• Operating pressure
  0 bar ... 0.5 bar
• Type of mounting
  With internal thread and centering sleeve
• Mounting position
  Any
• Material of dosing needle
  High-alloy stainless steel
• Wire ends
  Stripped
• Internal volume
  113 µl valve with fluid connections
• Typical dosing precision
  <1% CV for volumes >5 µl <2.5% CV for volumes between 1-5 µl
• Contamination level
  2
• On switching time
  7 ms
• Max. switching frequency
  4 Hz
• Shock resistance
  Shock test with severity level 2 as per FN 942017-5 and EN 60068-2-27
• Temperature of medium
  5 °C ... 50 °C
• Fluid connector
  UNF1/4-28
• Duty cycle
  100 % with individual mounting 50 % in case of block mounting (max. switch-on time 1 s)
• Electrical connection
  2-wire Open end
• Product weight
  18 g
• Note on dosing volume
  Depending on the configuration, environment and application
Nominal altitude of use above sea level
<= 2000 m NHN
Application note
See application note (available on the support portal at festo.com)
Min. dosing volume
1 µl
Electrical power consumption
1.8 W
Type of control
Direct
Corrosion resistance class (CRC)
0 - No corrosion stress
Actuation type
Electrical
Materials in contact with the media
ETFE High-alloy stainless steel
Material number for dosing needle
1.4301
Nominal width of dosing needle
0.32 mm
Note on switching frequency
Dependent on the ambient temperature and installation state
Note on switching time on
Depending on the configuration, environment and application
Note on degree of protection
In mounted state
Switching time off
2 ms
Sealing principle
Soft
Vibration resistance
Transport application test with severity level 2 as per FN 942017-4 and EN 60068-2-6
Ambient temperature
5 °C ... 40 °C
Valve function
2/2, closed, monostable
Width dimension
9 mm
Storage temperature
-20 °C ... 70 °C
Water flow rate at max. operating pressure
370 µl/s
Note on dosing precision
Depending on the configuration, environment and application
Medium
Liquid media
Length of dosing needle
30 mm
Nominal width
0.8 mm
Reset method
Mechanical spring
Permissible voltage fluctuations
+/- 10 %
Note on materials
Contains paint-wetting impairment substances RoHS-compliant
Relative air humidity
0 - 95 % Non-condensing
Information on medium
Observe resistance of materials that come into contact with media
Note on switching time off
Depending on the configuration, environment and application
Type code
VTOE
Nominal operating voltage DC
24 V
Degree of protection
IP30

8063372 Related Documents