8063371 Festo Manifold Dispensers

Product Details

• Material number for dosing needle
  1.4301
• Product weight
  18 g
• Note on switching frequency
  Dependent on the ambient temperature and installation state
• Nominal altitude of use above sea level
  <= 2000 m NHN
• Note on switching time on
  Depending on the configuration, environment and application
• Length of dosing needle
  30 mm
• Nominal width
  0.8 mm
• Max. switching frequency
  4 Hz
• Temperature of medium
  5 °C ... 50 °C
• Actuation type
  Electrical
• Fluid connector
  UNF1/4-28
• Duty cycle
  100 % with individual mounting 50 % in case of block mounting (max. switch-on time 1 s)
• Nominal conductor cross section
  AWG28
• Cable length
  0.15 m
• Note on dosing precision
  Depending on the configuration, environment and application
• Information on medium
  Observe resistance of materials that come into contact with media
• Note on degree of protection
  In mounted state
• Electrical power consumption
  1.8 W
• Type of control
  Direct
• Shock resistance
  Shock test with severity level 2 as per FN 942017-5 and EN 60068-2-27
Note on materials
Contains paint-wetting impairment substances RoHS-compliant
Materials in contact with the media
ETFE High-alloy stainless steel
Storage temperature
-20 °C ... 70 °C
Note on dosing volume
Depending on the configuration, environment and application
Application note
See application note (available on the support portal at festo.com)
Note on switching time off
Depending on the configuration, environment and application
On switching time
7 ms
Sealing principle
Soft
Permissible voltage fluctuations
+/- 10 %
Valve function
2/2, closed, monostable
Note on fluid connector
Fitting enclosed for pneumatic tubing with 3 mm outside diameter
Wire ends
Stripped
Width dimension
9 mm
Nominal width of dosing needle
1 mm
Operating pressure
0 bar ... 0.5 bar
Typical dosing precision
<1% CV for volumes >5 µl <2.5% CV for volumes between 1-5 µl
Medium
Liquid media
Switching time off
2 ms
Reset method
Mechanical spring
Vibration resistance
Transport application test with severity level 2 as per FN 942017-4 and EN 60068-2-6
Ambient temperature
5 °C ... 40 °C
Type of mounting
With internal thread and centering sleeve
Mounting position
Any
Material of dosing needle
High-alloy stainless steel
Electrical connection
2-wire Open end
Internal volume
113 µl valve with fluid connections
Water flow rate at max. operating pressure
2000 µl/s
Relative air humidity
0 - 95 % Non-condensing
Contamination level
2
Min. dosing volume
5 µl
Type code
VTOE
Nominal operating voltage DC
24 V
Corrosion resistance class (CRC)
0 - No corrosion stress
Degree of protection
IP30

8063371 Related Documents