8063370 Festo Manifold Dispensers

Product Details

• Type of mounting
  With internal thread and centering sleeve
• Materials in contact with the media
  ETFE High-alloy stainless steel
• Material of dosing needle
  High-alloy stainless steel
• Nominal width of dosing needle
  0.6 mm
• Internal volume
  113 µl valve with fluid connections
• Note on dosing volume
  Depending on the configuration, environment and application
• Information on medium
  Observe resistance of materials that come into contact with media
• Note on degree of protection
  In mounted state
• Nominal width
  0.8 mm
• Reset method
  Mechanical spring
• Permissible voltage fluctuations
  +/- 10 %
• Ambient temperature
  5 °C ... 40 °C
• Note on fluid connector
  Fitting enclosed for pneumatic tubing with 3 mm outside diameter
• Nominal conductor cross section
  AWG28
• Note on dosing precision
  Depending on the configuration, environment and application
• Nominal altitude of use above sea level
  <= 2000 m NHN
• Medium
  Liquid media
• Electrical power consumption
  1.8 W
• Max. switching frequency
  4 Hz
• Note on materials
  Contains paint-wetting impairment substances RoHS-compliant
Valve function
2/2, closed, monostable
Duty cycle
100 % with individual mounting 50 % in case of block mounting (max. switch-on time 1 s)
Width dimension
9 mm
Cable length
0.15 m
Water flow rate at max. operating pressure
1300 µl/s
Typical dosing precision
<1% CV for volumes >5 µl <2.5% CV for volumes between 1-5 µl
Contamination level
2
Switching time off
2 ms
Sealing principle
Soft
Degree of protection
IP30
Material number for dosing needle
1.4301
Electrical connection
2-wire Open end
Product weight
18 g
Note on switching frequency
Dependent on the ambient temperature and installation state
Application note
See application note (available on the support portal at festo.com)
Note on switching time off
Depending on the configuration, environment and application
Length of dosing needle
30 mm
On switching time
7 ms
Type of control
Direct
Vibration resistance
Transport application test with severity level 2 as per FN 942017-4 and EN 60068-2-6
Temperature of medium
5 °C ... 50 °C
Fluid connector
UNF1/4-28
Mounting position
Any
Wire ends
Stripped
Storage temperature
-20 °C ... 70 °C
Operating pressure
0 bar ... 0.5 bar
Relative air humidity
0 - 95 % Non-condensing
Note on switching time on
Depending on the configuration, environment and application
Min. dosing volume
3 µl
Type code
VTOE
Nominal operating voltage DC
24 V
Shock resistance
Shock test with severity level 2 as per FN 942017-5 and EN 60068-2-27
Corrosion resistance class (CRC)
0 - No corrosion stress
Actuation type
Electrical

8063370 Related Documents